Avaya S8300 - Manual (Page 77)

About connection and login methods
Issue 9.1 June 2006 77
4. Login at the Welcome to Avaya P330 screen.
Login: xxx from the planning documentation
Password: xxx from the planning documentation
You are now logged-in at the Supervisor level. The prompt appears as P330-1(super)#.
Note:
Note:
To check the syntax of a command in the command line interface, type as much
of the command as you know followed by help. For example:
P330-1(super)#> set help
you will be given the current list of set commands available. If you type:
P330-1(super)#> set interface help
you will be given a much more restricted list of command possibilities that
address the possible interfaces to be set.
For a complete list of command line interface commands, type help or refer to the Avaya
P330T User’s Guide (available at
http://www.avaya.com/support ).
Logging in to the P330 Stack Processor with a LAN Connection
To log in with a LAN connection:
1. With a connection to the customer’s LAN (either remotely or on site), telnet to the P330
Stack Processor IP address.
Type telnet , where is the IP address of
the P330 stack master processor on the customer’s LAN.
2. Login at the Welcome to Avaya P330 screen.
Login: xxx from the planning documentation
Password: xxx from the planning documentation
You are now logged-in at the Supervisor level. The prompt appears as P330-1(super)#.