Avaya S8300 - Manual (Page 534)

Manual installation of a new G700 with an S8300
534 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
6. Press F3 (Enter) to save your changes.
If properly administered, the G700 should register with the primary controller within 1–2
minutes. The IP Address, MAC Address, and Module Type fields are populated
automatically after the G700 media gateway registers with the server.
7. Type change media-gateway to view the Media Gateway screen.
Media Gateway screen (after registration with primary controller)
The media modules installed in the G700 are listed next to their slot numbers. Verify that a
G700 media gateway has been successfully added.
To verify changes
1. At the SAT prompt, type list media-gateway.
Media-Gateway Report screen
change media-gateway 1 Page 1 of 1
MEDIA GATEWAY
Number: 1 IP Address: 135.9.41.150
Type: g700 FW Version/HW Vintage: 21.13.0 /0
Name: Swainsons MAC Address: 00:04:0d:02:06:ca
Serial No: 012X06230551 Encrypt Link? y
Network Region: 1 Location: 1
Registered? y Controller IP Address: 135.9.41.146
Site Data:
Slot Module Type Name
V1: S8300 ICC MM
V2: MM712 DCP MM
V3: MM711 ANA MM
V4: MM710 T1/E1 MM
V8:
V9:
list media-gateway
MEDIA-GATEWAY REPORT
Num Name Serial No/ IP Address/ Type NetRgn Reg?
FW Ver/HW Vint Cntrl IP Addr RecRule
1 LabA 01DR07128730 135.177.49.57 g700 1 y
21 .13 .0 /0 135.177.49.59 1
2 Data MG2 02DR01130356 135.177.49.90 g350 1 n
11 .2 .0 /0 135.177.49.40 none