Avaya S8300 - Manual (Page 702)

Manual upgrade of an existing S8300B and G700 to R3.1
702 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Restoring the 4600-series phone configuration file, if any
If you copied a 4600-series phone configuration file to the /var/home/ftp/pub directory prior to
the upgrade, you should restore it after the upgrade. However, before you restore the file, be
sure you have downloaded the appropriate IP phone firmware.
1. At the Linux command line, type cd ~ftp/pub, and press Enter.
2. At the prompt, type cp 46xxsettings.txt /tftpboot, and press Enter.
The 4600-series phone settings file is now restored to the /tftpboot directory.
Upgrade the G700 Firmware
This section describes how to upgrade firmware on the components of the G700, including the
Media Gateway Processor (MGP), the P330 Stack Processor, and any installed media modules.
Manually upgrading G700 firmware
Conduct the following manual procedures to update the firmware running on the G700 Media
Gateway processors and media modules:
G700 Pre-Upgrade Tasks
1. Verifying the contents of the tftpboot directory on page 703
2. Determining which firmware to install on the G700 on page 704
G700 Upgrade Tasks
1. Installing new firmware on the P330 stack processor on page 706
2. Installing new firmware on the G700 Media Gateway Processor on page 706
3. Installing new firmware on the media modules on page 708
4. Installing new firmware on other G700 media gateways on page 711