Avaya S8300 User Manual
Page 211
Administer Communication Manager
Issue 9.1 June 2006
211
1. At the SAT command line, type add survivable-processor
is the LSP name from the Node Names screen.
The Survivable Processor screen appears.
Figure 20: Add Local Survivable Processor screen
2. The type field is automatically populated with LSP. LSP appears in the field if the node
name is not associated with ESS.
3. Enter a network region for the LSP. The default is 1. However, there may be a different
network region better suited for the LSP to provide media gateway and IP phone support.
Administering the Media Gateway
on page 221 to continue.
Administering an S8400, S8500, or S8700-series primary
controller
Complete the procedures in this section if the primary controller for the G700 you are installing
is an S8400, S8500, or S8700-series Media Server. If the primary controller is an S8300, you
should have completed the procedures in
Administering an S8300 primary controller
This document covers only the administration of Communication Manager required for the
G700 media gateway to communicate with the primary controller over a customer’s network.
For the majority of required administration, see Administrator Guide to Avaya Communication
Manager, 03-300509, or Administration for Network Connectivity for Avaya Communication
Manager, 555-233-504.
In this section, you will use the SAT interface on the primary controller to:
●
Assigning Node Names and IP Addresses for the C-LANs and LSPs
●
●
Assigning LSPs to the Network Regions
●
●
Identifying the Survivable Processor on the primary controller
add survivable-processor sv-mg2-lsp
Page 1 of xx
SURVIVABLE PROCESSOR - PROCESSOR ETHERNET
Node Name: sv-mg2-lsp
IP Address: 128.256.173.101
Type: LSP
Network Region: 1