Videoswitch VK-2 - Manual (Page 75)

VK-2 Universal Keyboard
VK-2 Universal Keyboard User Manual
72
• Move the dome to the position at which you wish to set a preset.
• Press and hold the ALT key and then press the STORE key.
• The display will show the letter “P—”, flashing.
• Press one of the number keys 1, 2, 3…16 to select a preset.
• Press and hold the ALT key and then press the STORE key to store the preset.
Presets can also be programmed via the in-built dome menu (Press
FUNCTION then SETUP to
access the menu).
19.6 Tours
19.6.1 Running a Tour
• Press
the
TOUR key.
• The display will show the letter “t—”.
• Press one of the number keys 1, 2 or 3 (or 4 for a tour of all presets) to run a tour that has
previously been stored.
• The dome will run the tour until the TOUR key is pressed again.
19.6.2 Programming a Tour
To start the tour programming:
• Holding
the
ALT key on, press the PROG key.
• The display will show the letter “t—”, flashing.
• Press one of the number keys 1, 2 or 3 to select a tour number.
• Holding
the
ALT key on, press the PROG key.
Repeat these steps for each position in the tour:
• The display will show the letters “PoS”, flashing (asking for a preset position).
• Enter the next preset position number 1, 2, 3…16.
• Holding
the
ALT key on, press the PROG key.
• The display will show the letters “dLL”, flashing (asking for a dwell time).
• Optionally enter a new dwell time (0, 1, 2…9 where each increment represents 2 seconds).
• Holding
the
ALT key on, press the PROG key.
• The display will show the letters “Spd”, flashing (asking for a speed)
• Optionally enter a new speed value to determine how long the dome takes to get from one position
to the next (
0, 1, 2…9 where each increment represents 2 seconds).
• Holding
the
ALT key on, press the PROG key, and repeat for all positions.