Videoswitch VK-2 - Manual (Page 32)

VK-2 Universal Keyboard
VK-2 Universal Keyboard User Manual
29
7.8.2 Programming a Tour
To start the tour programming:
• Holding
the
ALT key on, press the PROG key.
• The display will show the letter “t—”, flashing.
• Press one of the number keys 1, 2, 3…16 to select a tour number.
• Holding
the
ALT key on, press the PROG key.
Repeat these steps for each position in the tour:
• The display will show the letters “PoS”, flashing (asking for a preset position).
• Enter the next preset position number 1, 2, 3…16.
• Holding
the
ALT key on, press the PROG key.
• The display will show the letters “dLL”, flashing (asking for a dwell time).
• Optionally enter a new dwell time (0, 1, 2…9 where each increment represents 2 seconds).
• Holding
the
ALT key on, press the PROG key.
• The display will show the letters “Spd”, flashing (asking for a speed).
• Optionally enter a new speed value to determine how long the dome takes to get from one position
to the next (
0, 1, 2…9 where each increment represents 2 seconds).
• Holding
the
ALT key on, press the PROG key, and repeat for all positions.
To finish programming a tour:
• The tour can be finished when the letters “PoS” are displayed, as follows:
• Holding
the
ALT key on, press the PROG key (i.e. without entering another position) to finish the
tour programming.
• The word “Fin” will be displayed, indicating that the tour programming has finished.
• Finally, Holding the ALT key on, press the PROG key to return the display to its normal mode.
7.9 Menus
See 5.9 for basic details. Also, while the “
Fn” is being displayed, some of the keys on the VK-2 have special
functions as follows:
• Press
the
INCIDENTS key to enter the dome supervisor menu.
• Press
the
EVENTS key to enter the dome technician menu.
If operating a Dennard dome using BBV protocol via coax, the BBV menu functions are accessed as follows:
• Holding
the
ALT key on, press one of the camera keys 1, 2, 3...15 to select one of the BBV menu
options (menu not visible). E.g.
ALT and 4 to choose to erase a preset.
• Press one of the camera keys 1, 2, 3...15 to set a value (e.g. 3 to erase preset number 3).
• Use
the
Up, Down, Left, Right arrow and YES keys to enter the title in the pop-up menu.