Videoswitch VK-2 - Manual (Page 13)

VK-2 Universal Keyboard
VK-2 Universal Keyboard User Manual
10
• Press
the
CAMERA key, and select a camera that is to be assigned. The LED display indicates the
camera number
1 to 16 and the currently assign dome output 1 or 2. For example, the display
“
C7.2” would indicate that camera 7 is controlled via the “DOMES-2” output.
• Press
the
NO key to select the “DOMES-1” output or press the YES key to select the “DOMES-
2” output.
• Repeat for all units and cameras as required.
1.5.6 Enabling Display Monitors
Each VK-2 keyboard can be set to have control of a limited choice of displays. For example, you may want
one VK-2 to be able to select cameras for the spot monitor (i.e. display
2) whilst another VK-2 can select
cameras for the main monitor (i.e. display
1).
• Make sure that you are in Configuration Mode as detailed in section 1.5.2.
• Press
the
DISPLAY key and select a display that you wish to enable or disable
• Press
the
YES key if you want this VK-2 to be able to select cameras on this display. Press the NO
key if you do not want this VK-2 to be able to select cameras on this display.
Note the LED display indicates the selected display and whether it is enabled for camera selection, for
example: “
D1.y” means that the main display monitor can be controlled, whereas “D2.n” would mean that
the spot monitor cannot be controlled.
1.5.7 Changing the Password
A new password may be set as follows:
• Make sure that you are in Configuration Mode as detailed in section 1.5.2.
• Holding
the
ALT key, press the 11 key.
• The LED display will show “PSd”.
• Enter the password using the number keys 1, 2, 3, 4, 5, 6, 7, 8, 9 and ZERO. Up to 8 digits may
be entered (only the last 3 are displayed)
• Press
the
YES key to save the new password (make sure you remember the password as it will be
required next time to wish to enter
Configuration Mode).
1.5.8 Enabling remote dome control from a VDM Digital recorder
Domes connected to the VK-2 can be controlled remotely via Ethernet, PSTN or ISDN via a Videoswitch
Digital Recorder (DVR). Use Vi-Connect as the remote access software. This provides a virtual joystick.
•
Single VK-2 When configuring the VK-2, press
ALT and 10 to enable the remote control
feature (the display will show ”
--|”).
•
Multiple VK-2 When configuring each of the keyboards except for the furthest in the daisy
chain from the DVR, press
ALT and 9 (the display will show ”---”). When
configuring the furthest in the daisy chain from the DVR, press
ALT and 10
(the display will show ”
--|”).
The VK-2 that is connected to the DVR should be connected with a CAT5 cable (or equivalent) that has all
pairs connected.
1.5.9 Enabling remote dome control from a VDC Digital recorder
Domes connected to the VK-2 can be controlled remotely via Ethernet, PSTN or ISDN via a Videoswitch
Digital Recorder (DVR). Use Vi-Connect as the remote access software. This provides a virtual joystick.
When configuring the keyboard or keyboards, press
ALT and 9 (the display will show ”---”).