Videoswitch VK-2 - Manual (Page 27)

VK-2 Universal Keyboard
VK-2 Universal Keyboard User Manual
24
• Press
the
TOUR key.
• The display will show the letter “t—”.
• Press one of the number keys 1 (sequence, default dwell and speed) or 2 (tour, individual dwell and
speed per preset).
• The dome will run the tour until the TOUR key is pressed again.
6.8.2 Programming Tour 1
To start the tour programming:
• Holding
the
ALT key on, press the PROG key.
• The display will show the letter “t—”, flashing.
• Press one of the number key 1 to select a tour number.
• Holding
the
ALT key on, press the PROG key.
Repeat these steps for each position in the tour:
• The display will show the letters “PoS”, flashing (asking for a preset position).
• Enter the next preset position number 1, 2, 3…16.
• Holding
the
ALT key on, press the PROG key, and repeat for all positions.
To finish programming a tour:
• Holding
the
ALT key on, press the PROG key (i.e. without entering another position) to finish
the tour programming.
• The word “Fin” will be displayed, indicating that the tour programming has finished.
• Finally, Holding the ALT key on, press the PROG key to return the display to its normal mode.
6.8.3 Programming Tour 2
To start the tour programming:
• Holding
the
ALT key on, press the PROG key.
• The display will show the letter “t—”, flashing.
• Press one of the number key 2 to select a tour number.
• Holding
the
ALT key on, press the PROG key.