Videoswitch VK-2 - Manual (Page 35)

VK-2 Universal Keyboard
VK-2 Universal Keyboard User Manual
32
8.6.2 Programming a Tour
To start the tour programming:
• Holding
the
ALT key on, press the PROG key.
• The display will show the letter “t—”, flashing.
• Press one of the number keys 1, 2, 3…16 to select a tour number.
• Holding
the
ALT key on, press the PROG key.
Repeat these steps for each position in the tour:
• The display will show the letters “PoS”, flashing (asking for a preset position).
• Enter the next preset position number 1, 2, 3…16.
• Holding
the
ALT key on, press the PROG key.
• The display will show the letters “dLL”, flashing (asking for a dwell time)
• Optionally enter a new dwell time (0, 1, 2…9 where each increment represents 2 seconds).
• Holding
the
ALT key on, press the PROG key.
• The display will show the letters “Spd”, flashing (asking for a speed).
• Optionally enter a new speed value to determine how long the dome takes to get from one position
to the next (
0, 1, 2…9 where each increment represents 2 seconds).
• Holding
the
ALT key on, press the PROG key, and repeat for all positions.
To finish programming a tour:
• The tour can be finished when the letters “PoS” are displayed, as follows:
• Holding
the
ALT key on, press the PROG key (i.e. without entering another position) to finish the
tour programming.
• The word “Fin” will be displayed, indicating that the tour programming has finished.
• Finally, Holding the ALT key on, press the PROG key to return the display to its normal mode.
8.7 Other Commands
180
° turn:
• Press and hold the ALT key and then press the F1 key.
Colour/mono toggle:
• Press and hold the ALT key and then press the F2 key.