Videoswitch Vi-R4000 Series - Manual (Page 54)

Vi-R4000 Series
Videoswitch Page 48 Mdr602a.doc
4.2 Spot Monitors
4.2.1 Using Vi-K1 remote keyboard
If you plug a Vi-K1(A) keyboard into KBD2 it will control monitor 2. If you plug a Vi-K1(A) keyboard into
KBD3
it will control monitor 3. If you plug a Vi-K1(A) keyboard into KBD4 it will control monitor 4.
• Enter
numbers to select cameras.
• Press
OK to start auto-sequencing (cameras and dwell time can be specified by interface
commands).
• Press
LIVE or select a camera to stop auto-sequencing
4.2.2 Using Vi-K1 to control other monitors
A Vi-K1 keyboard plugged into any of the four KBD ports can be made to behave as if it is plugged into
any of the other KBD ports as follows.
Control DVR as if plugged into KBD1 port (i.e. monitor 1)
Press and hold ESC key, press 1
Control DVR as if plugged into KBD2 port (i.e. monitor 2)
Press and hold ESC key, press 2
Control DVR as if plugged into KBD2 port (i.e. monitor 2)
Press and hold ESC key, press 3
Control DVR as if plugged into KBD2 port (i.e. monitor 4)
Press and hold ESC key, press 4
To make the keyboard revert to it’s normal control port:
Press and hold ESC key, press 0
4.2.3 Using Vi-K2(A) remote keyboard
A Vi-K2(A) keyboard is capable of controlling any monitor when plugged into any keyboard port by
selecting the display monitor 1 to 4 on the keyboard, then entering the camera number (use may be
restricted in the keyboard if required).
You can also route cameras 1-16 to the various monitors from the DVR’s front panel keypad as
follows:
• BNC Monitor 1 - enter 1 to 16
• BNC Monitor 2 - enter 101 to 116
• BNC Monitor 3 - enter 201 to 216
• BNC Monitor 4 - enter 301 to 316