ARI Armaturen ARImetec-S EN - Manual (Page 22)

Page 2-22 Rev. 0040807015 1014
Operating Instructions
ARImetec
®
-S
6.9.2 Auto-Power-Off
The Auto-Power-Off function allows you to switch off the ARImetec
®
-S again automatically
after a set time. You can set a time between 1 and 25 min in steps of 1 minute by turning the
control knob. Press button "F1" to return to the previous menu or "F3" to return to check
mode.
6.9.3 Auto-Light-Off
The Auto-Light-Off function allows you to switch off the display backlighting again
automatically after a set time. You can set a time between 0 and 2 min in steps of 30
seconds by turning the control knob. Press button "F1" to return to the previous menu or
"F3" to return to check mode.
6.9.4 Contrast
You can adjust the display contrast in the "Contrast" menu by turning the control knob in
order to ease legibility in poor lighting conditions. The new contrast setting takes effect on
the screen immediately. Press button "F1" to return to the previous menu or "F3" to return to
check mode.
6.9.5 Language
You can display the menus on the ARImetec
®
-S in either English or German.
You set the language in the "Language" menu by turning the control knob. Press button
"F1" to return to the previous menu or "F3" to return to check mode.
6.10 PC connection / data transfer
The ARImetec
®
-S has a USB interface that allows it to be connected to a PC.
"SONAPHONE Communicator", the PC software available as an accessory, is required to
communicate with the PC. This software includes all the drivers you need to log your
ARImetec
®
-S into the operating system and supply it with power from the PC. The device
cannot be operated from a PC without these drivers. "SONAPHONE Communicator"
provides the following functionality:
- Analysis and management of single tests
- Pre-parameterisation of single tests
- Analysis and management of long-time tests
- Pre-parameterisation of long-time tests
- Archival of test data
- Online testing
- Setting device parameters
- Memory management
ATTENTION !
- The ARImetec
®
-S must not be connected to the PC if the lid of the battery
compartment is open! If you open the lid while the ARImetec
®
-S is connected
to the PC, you could damage the device!