ARI Armaturen ARImetec-S EN - Manual (Page 12)

Page 2-12 Rev. 0040807015 1014
Operating Instructions
ARImetec
®
-S
6.5 Check mode
6.5.1 Operating elements
6.5.2 Adjusting the volume
6.5.3 Storing the measured / test value
- Turning the control knob: Adjusts the
volume
- Pressing the control knob:
Stores test values
(refer to section 6.7.3 Single test)
- F1 (Max):
Selects the "Max" function
- F2 (Hold):
Selects the "Hold" function
- F3 (Menu):
Opens the Options menu, in which
you can change the device
configuration
- "LIGHT":
Controls the backlighting
(Off - Level I - Level II - Level I - Off)
- When you turn the control knob, a volume bar
and an intensity value appear for
approximately 2 seconds as shown in the
picture opposite.
- Turn the knob clockwise to increase the
volume or anticlockwise to reduce it.
- By pressing this button in check mode
(assuming at least one single test has been
parameterised), you store the ultrasonic level
and the current temperature in the single test
selected as "Active". The word "Save"
appears on the display for a few seconds
while the values are being stored, together
with the name of the single test.
Control knob
LIGHT
Buttons