ARI Armaturen ARImetec-S EN - Manual (Page 14)

Page 2-14 Rev. 0040807015 1014
Operating Instructions
ARImetec
®
-S
6.6.2 Operation
6.7 Data logger
6.7.1 General
The built-in data logger allows you to store ultrasonic levels and measured temperature
values. Each stored data set comprises the date, time, tester's name (max. 8 characters),
test point (max. 8 characters), sensor type, ultrasonic level and temperature value. There
are two possible test types:
- Long-time test:
Ultrasonic level and temperature values are stored at regular intervals over a long period
of time. Up to 250 long-time tests with 75 data sets or 1 long-time test with 21,000 data
sets can be recorded. Each data set consists of an ultrasonic level and a measured
temperature value.
- Single test:
The current ultrasonic level and temperature value are stored in a data set. Up to 250
single tests with 23 data sets or 1 single test with 6300 data sets can be recorded.
Use "SONAPHONE Communicator" (PC software available as an accessory) to archive the
measurement data.
6.7.2 Long-time test
When you select the "Long-time test" function, you see an overview of all long-time tests
created so far, together with their respective test points and creation dates:
The main menu contains three sub-menus:
1. Data logger:
Store measured and test values
2. Test parameters:
Change all test-specific parameters
3. Options:
Change the device parameters
You select a menu by turning the control knob and
open it by pressing the knob. By pressing button
"F3", you return to check mode. The currently
selected menu is indicated by a solid circle with a
dot (radio button).
You can choose between four possible actions in
this menu:
- Pressing the control knob:
Display more information about the selected long-
time test
- F1 (Back):
Return to the "Data logger" menu
- F2 (New):
Create a new long-time test
- F3 (Select):
Record test values for the selected long-time test