Red Lion TLA - Manual (Page 9)

9
C
ONFIGURE
M
ODULE
9 - F
ACTORy
S
ERvICE
O
PERATIONS
(9-FS)
DISPLAY PARAMETER RANGE DESCRIPTION/ COMMENTS
CodE
Factory service function
code
48 - Calibrate instrument TLA calibration. Refer to the Calibration section for details.
66 - Reset parameters to factory
settings
Entering code 66 restores all parameters to factory settings. The
unit indicates the operation after the P button is pressed, by
displaying “rSEt” in the lower display momentarily.
77 (twice in succession) -
Reset TLA calibration to nominal
values
Caution: this operation erases the TLA calibration values and
defaults the values to nominal settings. Reading errors of ±10%
may result. Do not perform this operation unless the TLA has lost
calibration. Loss of calibration is signaled by an “E-CL” error
flag at power-up. To clear this flag, perform calibration procedure
as noted in the Calibration section. Alternatively, “stepping” through
one of the calibration procedures clears the error flag, but does
NOT validate the calibration accuracy in any manner.
USER PARAMETER VALUE CHART
TLA Number _____________
MNEMONIC PARAMETER USER SETTING

AL-2

L-1
Limit Setpoint
Alarm 2 Value
Password
Alarm 1 Value
1-N Input Parameters
MNEMONIC PARAMETER USER SETTING
SCAL
SPL
FLt
tPE
SFt
SP
CPt
Temperature Scale Units
Limit Setpoint Lower Limit
Digital Filtering
Input Sensor Type
Input Offset
Limit Setpoint Upper Limit
Temperature Resolution
2-P Output Parameters
MNEMONIC PARAMETER USER SETTING
LAc Limit Output Trip Action
-LC Lockout Parameters
MNEMONIC PARAMETER USER SETTING
AL
FPS
PASS
Alarm(s) Access Level
Front Panel Reset
Password
-AL Configure Alarm Parameters
MNEMONIC PARAMETER USER SETTING
t1
t2
L-2
L-1
S
Act1
Act2
t2
t1
Alarm 1 Reset Mode
Alarm 2 Reset Mode
Alarm 2 Value
Alarm 1 Value
Alarm Hysteresis Value
Alarm 1 Action Mode
Alarm 2 Action Mode
Alarm 2 Standby Enabled
Alarm 1 Standby Enabled