beautypg.com

Ommunicating, Configuring a g09, Usb, data transfers from the sd card – Red Lion G09 9" LCD color touch panel User Manual

Page 3: Insertion/removal of the sd card

background image

3

TYPE B

USB

ST

AT

US USB HOST

ST

AT

US

PORT B

PORT A

COMM

RT

S (PIN 6)

Tx

CTS (PIN 1)

Rx

COMM

RT

S (PIN 6)

Rx

COMM

Tx

COMM

CTS (PIN 1)

(NIC)

ETHERNET

Rx

B

Tx

A

(PIN 8)

COMM

Tx

B

TxEN

TxB (PIN 1)

Rx

A

Tx

A

AUXILIARY

ETHERNET

(NIC)

COMMS PORT

PGM PORT

COMMS PORT

RS232

RS485

RS232

DEVICE

USB

POWER

-

+

USB HOST

PORT A (PGM)

ETHERNET

RS232

RS232

PORT B

PORT A

RS485

AUXILIARY

ETHERNET

POWER

CHASSI

S

COMMO

N

+DC VO

LT

AG

E

1

2

3

CONNECTOR

[OPTIONAL]

G09 PORT PIN OUTS

CONFIGURING A G09

The G09 is configured using Crimson

®

software. Crimson is available as a

free download from Red Lion’s website. Updates to Crimson for new features

and drivers are posted on the website as they become available. By configuring

the G09 using the latest version of Crimson, you are assured that your unit has

the most up to date feature set. Crimson

®

software can configure the G09

through the RS232 PGM port, USB port, or SD.

The USB port is connected using a standard USB cable with a Type B

connector. The driver needed to use the USB port will be installed with Crimson.

The RS232 PGM port uses a programming cable made by Red Lion to

connect to the DB9 COM port of your computer. If you choose to make your own

cable, use the “G09 Port Pin Out Diagram” for wiring information.

The SD can be used to program a G09 by placing a configuration file and

firmware on the SD card. The card is then inserted into the target G09 and

powered. Refer to the Crimson literature for more information on the proper

names and locations of the files.

USB, DATA TRANSFERS FROM THE SD CARD

In order to transfer data from the SD card via the USB port, a driver must be

installed on your computer. This driver is installed with Crimson and is located

in the folder C:\Program Files\Red Lion Controls\Crimson 3.0\Device\ after

Crimson is installed. This may have already been accomplished if your G09 was

configured using the USB port.

Once the driver is installed, connect the G09 to your PC with a USB cable,

and follow “Mounting the SD” instructions in the Crimson 3 user manual.

INSERTION/REMOVAL OF THE SD CARD

Insert the SD card into the slot provided with the card oriented as shown. The

card is inserted properly when the end of the card is flush with the Graphite

case. To remove the SD card, push in slightly on the card.

WARNING - DO NOT CONNECT OR DISCONNECT CABLES

WHILE POWER IS APPLIED UNLESS AREA IS KNOWN TO BE

NON-HAZARDOUS. USB PORT IS FOR SYSTEM SET-UP AND

DIAGNOSTICS AND IS NOT INTENDED FOR PERMANENT

CONNECTION.

c

OmmunIcatIng

W

Ith

the

g09