Grounding the cables – Vaisala PTB330 User Manual
Page 28
USER'S GUIDE____________________________________________________________________
26 __________________________________________________________________ M210855EN-D
Grounding the Cables
To ensure the best possible EMC performance, you must ground the screen of the electrical cable as shown in
Figure 16 below and in the instructions below that.
1212-005
Figure 16
Grounding the Screen of Electrical Cable
To ground the electrical cables:
1.
Cut back outer sheath to desired length.
2.
Cut back screen braiding or screen foil to dimension X (see
1212-005
3.
Push the domed cap nut (item 1) and the seal insert with contact
socket of the gland (item 2+3) onto the cable as shown in the
diagram.
4.
Bend over the screen braiding or screen foil by about 90° (item
4).
5.
Push the seal insert with the contact socket of the gland (item
2+3) up to the screen braiding or screen foil.