Vaisala DMT143 - Manual (Page 41)

Chapter 5 _________________________________________________________________ Operation
VAISALA ________________________________________________________________________ 39
Device Information
Show Device Information
The ? command outputs a listing of device information.
?
Command ?? is a similar command that is designed to be used if the
transmitter is in POLL mode but its address is unknown. The transmitter
will respond to the ?? command even while in POLL mode. Do not use
the ?? command if you have more than one transmitter on an RS-485
line.
Example:
?
DMT143 1.0.2
Serial number : H1220011
Batch number : H1210003
Sensor number : G3320000
Sensor model : DRYCAP180D
Cal. date : 20120412
Cal. info : VAISALA/HEL
Time : 01:38:00
Serial mode : STOP
SCI Baud P D S: 19200 N 8 1
Output interval: 1 S
Serial delay : 30
Address : 0
Pressure : 1.013 bar
Filter : 0.100
Show Analog Output Mode
Use the AMODE command to show the analog output mode:
AMODE
Example:
amode
Ch1 output : 4 ... 20 mA