beautypg.com

Operation, Transmitter start-up, Chapter 5 – Vaisala DMT143 User Manual

Page 35: Chapter 5, operation, c

background image

Chapter 5 _________________________________________________________________ Operation

VAISALA ________________________________________________________________________ 33

CHAPTER 5

OPERATION

This chapter contains information that is needed to operate the DMT143.

Transmitter Start-Up

When the transmitter is connected to power supply (for instructions on
selecting the correct operating voltage, see section Power Supply
Requirements on pa
ge 23), there is a delay of two seconds as the
transmitter starts up. After the start-up is complete, the measurement data
is available from the analog output and serial line.

For a description of how the diagnostic functions of the sensor affect the
availability of live measurement at start-up, see section DMT143 Startup
Sequence on page 17.

If serial line output is used, note that the transmitter will behave
according to the configured serial mode:

- In STOP mode, the transmitter outputs the transmitter model and

software version. This is the default mode.

- In RUN mode a measurement output starts immediately.

- In POLL mode the transmitter does not output anything after power-

up.

For a description of the modes, see section Set Serial Line Operating
Mode on page 53.