Vaisala HMT140 User Manual
Page 34
Connecting to your Network
26
VAISALA
3
Plug the USB connector on the HMT140 Configuration
Cable to the computer, if it is not already connected.
4
From the start menu, open the HMT140 Utility.
5
Connect the end of the Configuration Cable labelled USB
Wi-Fi Programmer,
to the 4-pin HMT140 CONFIG
header.
6
On the HMT140 Setup tab, click Retrieve to identify
the HMT140. The bottom left status bar will initially
read, Looking for sensor or USB programmer,
then, once the HMT140 is identified, the status bar will
read, Found USB Programmer.
7
Click Retrieve again to force retrieval of current settings
Note:
The connected Transmitter type is identified in
the upper right corner of the Setup tab window.
The status bar is located at the bottom of the HMT140
Utility window. It contains the following panels:
Left panel:
Displays the Configuration Cable status:
Found USB Programmer or Looking for USB Program-
mer.