Mounting, Wall mounting – Vaisala HMT140 User Manual

Page 22

Mounting

VAISALA

Mounting

Depending on your installation requirements, you may wish

to complete the network configuration and setup prior to

you can complete the configuration and setup procedures

after mounting with a portable PC.

Note:

To connect the HMT140 to your network

and view HMT140 data using viewLinc, you

require HMT140 Utility software and an

HMT140 Configuration Cable (shipped with

viewLinc).

Wall Mounting

To mount the HMT140 on a wall:

Note:

If mounting against a metal surface, be sure to

keep a minimum of 2 mm between the metal and

the back of the device to ensure an uninterrupted

radio signal.

Open the HMT140 cover. Use your thumb to press and

hold the release tab located between the two glands (see

Figure 9 on page 19), then pull the cover out and up with

your other hand.

Make sure that the HMT140 is correctly aligned and

attach it directly to the wall with up to four screws (not

included in the package).

• Select the size and type of the fastening screws

according to the wall material (for example, wood or

stone). The diameter of the fastening screws is

typically between 3.5 and 4 mm.