Vaisala HMT140 - Manual (Page 19)

Introduction to the HMT140
M211488EN-C 11
The following numbers refer to Figure 1:
1
Transmitter enclosure
2 Cable bushing: cable gland.
3 Probe cable
4 HMP110 probe
5 Plastic grid filter
Installation Kit
The device is typically installed mounted on the wall with up
to four screws (not included). See Figure 2 on page 15.
For duct mounting, Duct Installation Kits are available as
accessories. See Options and Accessories, on page 8.
To help you position the screws correctly, use the Drilling
Template, available inside the back cover of the Quick Guide.
HMT140 Utility and Configuration Cable
To connect an HMT140 device to your network, you will need
to install the HMT140 Utility software and connect the device
to your PC with the configuration cable (see, Connecting to
your Network, on page 24).