WeatherHawk Inversion - Wireless - Manual (Page 28)

WeatherHawk ® 25
815 W. 1800 N. Logan, Utah 84321-1784, Email: [email protected] Copyright © 2004, 2010
Toll free in USA: 866-670-5982, International: 435-750-1802, FAX: 435-750-1749 Printed November 2010
5. Inspect system enclosure
•
Check outside of system enclosure for damage and corrosion
o Clean outside of enclosure
•
Open system enclosure and check for insects and spiders
o Remove any insects or spiders
•
Visually inspect wires/cables inside enclosure for frays and breaks
•
Ensure battery is secured to mounting bracket with strap
o Tighten battery strap if loose
•
Ensure enclosure is securely mounted to mast
o Tighten any loose nuts/bolts
6. Inspect solar panel (if equipped)
•
Inspect solar panel for damage, corrosion, and cleanliness
o Replace any damaged panels
o Clean panels if necessary
7. Inspect all sensor, power, and communication cables
•
Inspect all system cables for breaks and frays
o Repair or replace any damaged cables
•
Ensure all cables are secured to mast using cable ties
o Secure any loose cables to mast using cable ties
For systems that are used for temporary installations, all maintenance procedures should be performed between
deployments or according to the above schedule if deployment time is greater than one month.
Do not spray insect/spider killer inside enclosure. Contact with these chemicals will damage
electronic components inside system enclosure.