AMX Modero MVP-5200i - Manual (Page 58)

Setup Pages
50 MVP-5200i Modero Viewpoint Widescreen Touch Panel
Setup Page (Cont.)
Connection Status: Displays whether the panel is has external communication, as well as the
encryption status of the Master, the connection type (Ethernet or USB), and to
which System the panel is connected.
• Until a connection is established, the message displayed is: “Attempting via
Ethernet” or "Attempting via USB".
• When a connection is established, the message displayed is either: “Connected
via Ethernet “or “Connected via USB “.
• The word “Encrypted” appears when an encrypted connection is established with
a NetLinx Master.
Note: The panel must be rebooted before incorporating any panel communication
changes and to detect Ethernet connections.
Display Timeout: Indicates the length of time that the panel can remain idle before activating Sleep
mode, causing the device to power down.
• Press the Up/Down buttons to increase/decrease the Display Timeout setting.
Range = NONE, 10 sec., 15 sec., 20 sec., 25 sec., 30 sec., 5 mins., 15 mins., 30
mins., 60 mins., 2 hrs.
• Set the timeout value to NONE to disable Sleep mode.
Note: Small timeout values maximize the life of the battery charge.
Advanced Power Settings button: Enabling this button disables various peripherals
that would otherwise remain powered while the device is in Sleep mode, including
the navigation wheel. When this button is enabled, pressing the
navigation wheel center will NOT wake up the panel, and only touching the touch
screen will awaken it. This feature is only active when the device is running on
battery power, and is not active when the device is on external power. When
enabled, Advanced Power Savings allows additional battery life of panel availabil-
ity without recharging.
Disable Timeout On External Power button: When enabled, the display will not go
into Timeout when external power is applied. The display always will go into the
preselected Display Timeout setting when on battery power.
Inactivity Page Flip
Timeout:
Indicates the length of time that the panel can remain idle before automatically
flipping to a pre-selected page.
• Press the Up/Down buttons to increase/decrease the Inactivity Page Flip
Timeout setting. Range = 0 - 240 (minutes).
• Set the timeout value to 0 to disable Inactivity Page Flip mode.
Note: The touch panel page used for the Inactivity page flip is named within a
small Inactivity Page field below the buttons.
Panel Brightness: Sets the display brightness and contrast levels of the panel.
• Press the Brightness Up/Down buttons to adjust the brightness level.
Range = 0 - 100.
NOTE: Be careful not to turn down the brightness too low to be able to see the
Setup page.
Sleep Blink LED: Enables and disables the blinking of the navigation wheel LED when the device is
in Sleep mode. When enabled, the LED blinks while the device is charging. The
Sleep Blink LED button is enabled by default.
NOTE: This feature will only apply when the device is in Sleep mode. When the
device is active, the state of the LED will match that of the display.