AMX Modero MVP-5200i - Manual (Page 12)

Introduction
4 MVP-5200i Modero Viewpoint Widescreen Touch Panel
Memory
The MVP-5200i comes with 128MB of Mobile DDRAM memory and 256 MB NAND Flash memory.
Neither may be upgraded.
Table Charging Station Connector Locations
With the unit facing you, the mini-USB port (for programming and downloading firmware as well as
connecting USB headphones using the AMX-provided adaptor cable) and the DC power port are located
on the lower left side of the device (FIG. 3). The connector for the Table Charging Station (please refer
to the Table Charging Station section on page 9) is located on the bottom of the device.
In addition to its speaker, the MVP-5200i also utilizes its mini-USB port as a connector for standard
headphones or headsets. These headphones must use a mini-USB plug or adaptor in order to utilize this
feature.
MVP-5200i Specifications (FG5966-01, FG5966-02) (Cont.)
Other AMX Equipment: • MVP-TCS-52: Table Charging Station (FG5966-1X)
• MVP-WCS-52: Wall Charging Station (FG5966-1X)
• MVP-BP-52: Battery Replacement Kit (FG5966-20)
• MVP-STYLUS-52-GB: Black Replacement Stylus, Pack of 3 (FG5966-21)
• MVP-STYLUS-52-GW: White Replacement Stylus, Pack of 3 (FG5966-22)
• CC-USB: USB Programming Cable (FG10-5965)
• MVP-HP USB 1/8" Adapter (FG5966-23)
This device complies with FCC Part 15 and Industry Canada RSS 210 subject to the
following conditions:
1. This device must not cause harmful interference and
2. This device must accept all interference, including interference that interferes with
the operation of this device.
FIG. 3 MVP-5200i side view with programming port
Front Mini-USB port
DC power port
Table Charging
Station Connector
Although firmware upgrades can be conducted over a wireless Ethernet connection,
transferring firmware KIT files over a direct USB connection is recommended, and
only when the panel is connected to a power supply. If battery power or wireless
connection fails during a firmware upgrade, the panel flash file system may become
corrupted.
While standard input/output headsets may be used in lieu of headphones, the
headset may only be used for output. While you may receive sound from the headset,
its microphone will not function. Always use the MVP-5200i’s microphone for
receiving sound.