GReddy TURBO KITS: Honda S2000 (AP2) 2004-06 / T518Z - Manual (Page 23)

― ２３―
3
－ － － －
13 Injector Installation
(1)
Apply a light amount of silicon grease to the O
rings on each injector. The smaller O ring at the
top and the two larger O rings at the base.
〈
Parts used:
１１〉
(2)
Remove the factory fuel rail. Be careful when
removing the fuel pulsation dampener and the fuel
pressure regulator. Be careful not to lose the seals
on both sides of the fuel pulsation dampener.
Have a rag to soak up the extra fuel that will leak
out.
(3)
Install the injectors to the factory fuel rail.
※
Be careful not to damage the O rings when
inserting the injectors into the fuel rail. Slowly
insert the injectors, being sure to keep the same
orientation of the injectors as factory.
(4)
Remove the 3 Factory studs shown and insert a
spacer onto each stud between the stud and the
intake manifold. Reattach the studs.
〈
Parts used:
１１〉
(5)
Attach the plug and play injector harness clips to
the factory injector clips.
※
Make sure the clips snap into place to make a
good connection.
〈
Parts used:
１２〉
(6)
Insert the fuel rail with the injectors installed into
the intake manifold. Be sure each injector is
seated properly and that none of the O rings have
fallen off or ripped.
(7)
Use the New silencer gasket and sealing washer
in place of the old gasket and washer on the fuel
pulsation dampener during reinstallation.
Use a zip tie on both ends of the vacuum hose
that goes from the fuel pressure regulator to the
intake manifold.
〈
Parts used: 80
〉
Zip ties
Ｏﾘﾝｸﾞ大× 2
Small
O Ring
Large O ring
X 2