GReddy TURBO KITS: Honda S2000 (AP2) 2004-06 / T518Z - Manual (Page 18)

― １８―
3-8 Air Pump Relocation
(1) Remove the lower mounting bolt from the air
pump, place the #67 bracket as shown. Use the
factory bolt in the same location it was taken to
secure the bracket down. Use the provided #89
nuts and bolts to relocate the pump towards the
front of the car, mounting it to the end of the #67
mounting bracket as shown.
〈
Parts used: 67
，
89
〉
(2) The air pump IN hose is the upper hose and the
OUT hose is the lower hose. Unclip the stay on
both hoses and position the IN hose so it sits
directly below the OUT hose as shown. Remove
the original stay that was holding the IN hose to
make room for the intercooler piping. Re-clip the
OUT hose once the IN hose is positioned below it.
3-9 Suction Pipe Installation
(1)
Install the #75 rubber vibration mount onto the
factory intake mounting bracket as shown.
〈
Parts used: 75
〉
№75
№67
IN
IN