DAVIS DriveRight Installation - GD (All DriveRight Models) - Manual (Page 6)

5
Step 1. D ISPLAY M OUNTING O PTIONS
The DriveRight comes with the hardware necessary for a variety of display mount-
ing options. The long harness cable (4) included with the DriveRight allows you to
install the display where you want it. You may, at your option, use the coiled cable
extension (3) for even greater convenience.
• Use the visor clip (5) to mount your display on a visor or door pocket. Install the
clip on the top or bottom of the display to orient the display as you wish (Figure
4). Push the clip in until the 3rd bump engages.
• Mount your display to the dash or center console. Choose a location and decide
how you want to mount the display: directly to the surface or using the mounting
bracket (6) and right angle adapter bracket (12). Then, decide how you want to
attach the display or the brackets: using VELCRO tape (15), double-sided foam
tape (14), or screws. Apply the two adhesive-backed loop tapes to the flats on the
back of the display (Figure 5) or to the back of the brackets. With the hook tapes
attached to the loop tapes, press adhesive backing of the hook tape onto your
selected mounting surface. Do not separate hook and loop tape for at least 24
hours after applying. Attach the mounting bracket to the right angle adaptor
bracket (12) with hardware provided as needed (Figure3). Mount the reversible
right angle adaptor bracket to desired location with hardware provided. Apply the
double-sided foam tape to mount the brackets if desired.
NOTE: For best results with foam tape or VELCRO, apply adhesive at room temperature of
68˚F (20˚C) or higher. Surface should be clean, dry and free of oils. Use clean wip-
ing materials with a cleaner appropriate for your vehicle’s interior to free surface of
contaminates and allow to dry. Peel release liner from back of tape and apply. (Take
care not to touch the adhesive with your fingers.) If adhesive must be applied at tem-
peratures lower than 68˚F (20˚C), warm substrate and the tape to elevate tempera-
ture prior to applying. This may help the bond cure. Allow 24 hours for full cure
before loading or cycling.
Figure 3: Bracket Mounting Options