DAVIS DriveRight Installation - GD (All DriveRight Models) User Manual

Page 20

Text mode
Original mode

3. With the ignition off, insert the DriveRight display cable into the harness cable

connector and lock the connectors. To do this, you will need to grasp the display
cable just behind the plastic sheath covering the connector, as shown below.
Push the display cable in until it locks into place.

Figure 27: Connecting the Display Cable to the Harness Cable

NOTE:

To disconnect the two cables, hold the plastic sheath on the display cable, as shown

below. Pull back until the two connectors separate.

Figure 28: Disconnecting the Display Cable and the Harness Cable

When the two cables are connected, the “BAT” should disappear, indicating that
the unit is drawing power from the vehicle’s battery. A dot may appear to the
right of where BAT was. This dot will be used to verify the magnet placement in
the next step.