DAVIS DriveRight Installation - GD (All DriveRight Models) - Manual (Page 16)

15
Figure 19: Wrong Way To Use Brackets
Step 5. W IRE R OUTING
Use the split flexible tubing (36) to protect the sensor leads from sensor up into the
vehicle cabin. Use the small tie wraps (37) to hold the leads against the underbody
of your vehicle. The tubing can be cut into pieces and used where the wires may rub
against sharp points or edges and where the leads are tie wrapped to the underbody.
Tubing can also be used where the leads are particularly exposed. If a vehicle wire
bundle is readily accessible, route the sensor leads along this wire bundle. The sen-
sor leads should be routed at least 12” (30 cm) away from sparkplug wires, the coil,
and the alternator. Loops, coils, and folds should be avoided in order to avoid creat-
ing unwanted interference that might result in erroneous readings.
Figure 20: Protecting the Wires