DAVIS Weather Wizard III - Manual (Page 29)

Using the Console Functions
Page 28 Weather Wizard III
5. Press ENTER to store that function in the scan routine.
6. Repeat steps 3,4, and 5 until you have entered all of the functions you wish to scan.
7. When you have entered all the desired functions, press SCAN.
The customized scan routine will begin. Note that the functions you enter will be
displayed in the same order they appear during the pre-programmed scan rou-
tine, not in the order you entered them.
To Clear a Customized Scan Routine
Press SCAN, then ENTER, then SCAN again.
To Change the Customized Scan Routine
To change a scan routine, follow the instructions above (in “To Program a Cus-
tomized Scan Routine”) to enter a whole new customized scan routine. You
cannot add or delete a function to an existing scan routine; you must re-enter
the scan routine in its entirety.
To Change the Unit of Measure Within the Scan Routine
Change the unit of measure as described in the individual section for the
desired function. Any changes made to the unit of measure outside of the scan
routine are reflected inside the scan routine.