DAVIS Weather Wizard III - Manual (Page 21)

Using the Weather Functions
Page 20 Weather Wizard III
4. Press RECL again to display the low.
After a few seconds, the display will show the time the low was recorded, and
then the date it was recorded.
5. Press any key to exit.
H IGH AND L OW T EMPERATURE D ISPLAYS
To Clear High and Low Temperatures
1. Press TEMP once or twice to select inside or outside temperature, as desired.
2. Press RECL once or twice to select the high or low temperature, as desired.
3. Press CLEAR and hold it down.
The display will flash several times, and then the old reading will be replaced by
the current temperature. As the temperature rises and falls, the high and/or low
will be updated.
4. Press any key to exit.
Note: High and low temperatures are independent of each other. Clearing the high temperature does
not clear the low temperature, and vice versa. You must clear each individually.
High and Low Temperature Alarms
For instructions on how to use the high and low temperature alarms, see
“Alarms” on page 24.
W IND S PEED AND W IND D IRECTION
The Weather Wizard III shows wind speed and wind direction in two places on
the display. They are always shown on the compass rose on the left hand side
of the display and can be selected to show on the right hand side.
About Wind Speed
Wind speed can be displayed in either miles per hour (MPH), kilometers per
hour (KPH), nautical miles per hour (KNOTS), or meters per second (M/S).
The wind speed readings on the right side of the display and in the compass
rose will always be in the same unit of measure.
The Weather Wizard III also records the highest wind speed at your location.
F
MPH
N
NE
SW
NW
SE
E W
S
OUTSIDE LOW
TEMPERATURE
High Inside Temperature: 27.2˚C Low Outside Temperature: 44˚F
MPH
N
NE
SW
NW
SE
E W
S
INSIDE
HIGH
C
TEMPERATURE