DAVIS Vantage Pro2 Quick Reference Guide - Manual (Page 7)

SOLAR SETUP
If you have a solar radiation sensor, press 2 ND & SOLAR to
display:
• Solar Radiation (W/m 2 )
To continue through the setup mode:
1. ENTER TIME. To change the time and date. See "TIME."
2. ENTER LATITUDE. Press
( + ) or ( − ) to change the flashing digit. Press
( < ) or ( > ) to move between fields. Press 2 ND & UNITS to change
from north to south.
3. ENTER LONGITUDE. Press ( + ) or ( − ) to change the flashing digit.
Press ( < ) or ( > ) to move between fields. Press 2 ND & UNITS to
change from west to east.
4. TIME ZONE. Press ( + ) or ( − ) to view time zones. Press 2 ND to enter
GMT offset instead of time zone. Press ( + ) or ( − ) to change GMT offset.
5. DAYLIGHT SAVINGS AUTO/MANUAL. Press ( + ) or ( − ). To change the
setting.
6. DAYLIGHT SAVINGS OFF/ON. If daylight savings setting = AUTO, dis-
plays the current status. If daylight savings setting = MANUAL, press ( + )
or ( − ) to change the current status.
7. ENTER ELEVATION. To correct barometric pressure. See "BAR."
8. WIND CUP SIZE SMALL/LARGE. Press
( + ) or ( − ) to change the setting.
9. RAIN COLLECTOR .01 IN/.2 MM/.1 MM. Press ( + ) or ( − ) to change the
setting.
10. RAIN SEASON BEGINS. Press ( + ) or ( − ) to change the month.
To exit the setup mode: Press and hold DONE .
26 7