DAVIS Soil Moisture/Temperature Station for Vantage Pro - Manual (Page 8)

Page 8 Wireless Soil Moisture/ Temperature Station
Mounting the Soil Moisture Station
Mounting on a Pole
1. While holding the shelter against the pole, place a U-bolt around the pole
and through the two holes on at the top of the shelter.
2. Place a flat washer, a lock washer and a hex nut on each of the bolt ends.
3. Using an adjustable wrench or 7/16" wrench, tighten the nuts.
4. Place the second U-bolt around the pole and through the two holes at the
bottom of the shelter.
5. Put a flat washer, a lock washer, and a hex nut on each bolt end, and tighten
the hex nuts.
Mounting on a Vertical Surface
1. With a 3/16" (5 mm) drill
bit, drill two holes
approximately 2" (50 mm)
apart. Use a carpenter’s
level to ensure the holes
will be level.
2. Drill two more holes 7-1/
32" below the upper holes.
3. Insert the 1/4" x 1-1/2" lag
screws through the flat
washers, and through the
holes at the top and bottom
of the shelter into the post.
4. Using an adjustable wrench
or 7/16" wrench, tighten
the lag screws.
Flat
Washer
Lock
Washer
Hex
Nut
U-Bolt
Mounting Soil Moisture Station on a Pole
Flat
Washer
Lag
Screw
Mounting Soil Moisture Station on a Vertical Surface