Setting the transmitter id code, To change to another transmitter id code, Id c – DAVIS ConsoleLink User Manual
Page 5
Setting the Transmitter ID Code
Page 5
S
ETTING
THE
T
RANSMITTER
ID C
ODE
The ConsoleLink uses any of eight selectable ID codes (the default is ID Code
#1). The transmitter and receiver communicate with each other only if they are
both set to the same ID code. Use the default setting unless you have another
Davis wireless system operating nearby which you want to work separately
from the new system. The dip switch settings for the eight possible codes are
shown in the table below.
To change to another transmitter ID code:
✦
Flip dip switches 1, 2, and/or 3 on the transmitter to the desired position using the
table above.
The transmitter and receiver must use the same ID code to communicate.
If you change the ID code on the transmitter, then you must change the
ID Code on the receiver to correspond.
C
HANGING
THE
D
IP
S
WITCHES
Note:
Use Dip switch #4 for testing, not for ID codes. (See ‘Testing Data Transmission” on page 6.)
When SET is on, the unit beeps each time data is transmitted.
ID C
ODE
D
IP
S
WITCH
1
D
IP
S
WITCH
2
D
IP
S
WITCH
3
#1
(default)
off
off
off
#2
off
off
ON
#3
off
ON
off
#4
off
ON
ON
#5
ON
off
off
#6
ON
off
ON
#7
ON
ON
off
#8
ON
ON
ON
UNIT ID
BEEP MODE
ON
BEEP MODE
OFF
1 2 3 4
ON
Dip Switches