DAVIS ConsoleLink - Manual (Page 3)

Attaching the ConsoleLink to the Host Weather Station Page 3
A TTACHING THE C ONSOLE L INK TO THE H OST W EATHER S TATION
The ConsoleLink has a short cable with a modular connector (ConsoleLink
connector) on its free end. Attach the transmitter to the host weather station as
follows:
1. Remove power from your weather
station.
2. Nest the ConsoleLink into the
console base.
3. Insert the ConsoleLink connector into
the weather station “WeatherLink” jack as
shown.
A TTACHING THE C ONSOLE L INK TO THE H OST S TATION
Note: We recommend not to plug in the power cord at this time. The diagram above is for you to refer
to when you power the ConsoleLink (see page 6).
A TTACHING A W EATHER L INK D ATA L OGGER (O PTIONAL )
You can attach a WeatherLink data logger to the ConsoleLink as follows:
1. Remove power from the
weather station.
2. Nest the ConsoleLink into
the console base as shown in
the diagram above.
3. Insert the ConsoleLink
connector into the weather
station “WeatherLink” jack.
4. Insert the WeatherLink
connector into the Con-
soleLink “WeatherLink” jack
5. Reinstall the Console base
following the instructions in
your host station manual.
A TTACHING A W EATHER L INK TO THE C ONSOLE L INK
WeatherLink
(optional)
ConsoleLink
inside console base
WeatherLink
External Cable
Power
Adapter
110 VAC
Power Outlet
Connection
to Computer
Antenna
ConsoleLink
To Power
Adapter
Weather Station
Console
"WeatherLink"
Jack
Console
Base
ConsoleLink
Connector
Power
Cord
"WeatherLink"
Pass-through Jack