beautypg.com

DAVIS WeatherLink Getting Started Guide User Manual

Page 18

background image

16

Troubleshooting Guide

When viewing data, dashes appear in place of a value for functions other than wind
direction. Why?

If no data was recorded by a sensor (for example, the sensor was disconnected
or radio interference blocked reception) or if bad data was recorded for a
sensor (for example, the sensor was malfunctioning), the software dashes out
the entry rather than showing invalid data. You can use the record editor to
correct these entries.

The data I want to see, such as humidity (Monitor) is missing completely or is
grayed-out. Why?

All optional sensors must be enabled in the Station Configuration Setup
dialog box before the data will be displayed in WeatherLink. If you are not
seeing data from a sensor that is installed in your weather station, be sure
check the Station Configuration in the Setup Menu and make sure the sensor
has been selected.