DAVIS Surge Protector Shelter - Large - Manual (Page 6)

Page 6 Large Surge-Protector Shelter
M OUNTING THE S HELTER
The instructions below will show you how to mount the shelter against a wall
or post, on a small pipe, or on a large pipe.
Mounting the Shelter on a Wall or Post
Attach the shelter to the mounting surface in the desired location using the lag
screws and
π
” flat washers as shown below.
M OUNTING ON A W ALL OR P OST
Mounting On a Small Pipe
Follow the instructions below to mount the shelter onto a pipe with outside
diameter between
Ω
” and 1
π
” (19 mm and 31 mm).
1. Hold the rear of the shelter and the 1
∫
” U-bolt saddles against the pipe and slide the
ends of the 1
∫
” U-bolts through the holes in the saddles and shelter so that the
U-bolts wrap around the pipe as shown below.
2. Secure the shelter using a
π
” flat washer and hex nut on each end of the U-bolts.
Tighten the hex nuts until the shelter is firmly attached to the pipe.
M OUNTING ON A S MALL P IPE