DAVIS Surge Protector Shelter - Large - Manual (Page 5)

Installing Surge Protectors and Ground Wires Page 5
Installing Ground Lug and Ground Jumpers
1. Attach the ground lug to the bottom of the shelter using a #10-32 x 1” (25 mm) screw,
washer, lock washer, and hex nut as shown below.
A TTACHING G ROUND L UG
2. Slide the spade lug on the end of one ground jumper over the #10-32 screw joining
the lowest pair of surge protectors. Secure in place using a #10 washer, lock washer,
and hex nut.
Repeat on the other side using the second ground jumper.
3. Slide the spade lug on each ground jumper over the end of the #10 screw holding the
ground lug in place. Secure the ground jumper using a #10 washer, lock washer, and
hex nut as shown below.
C ONNECTING G ROUND J UMPERS TO G ROUND L UG