DAVIS Multi-purpose Shelter - Manual (Page 8)

Multi-Purpose Shelter
6
M
OUNTING THE
MPS
The instructions below will show you how to mount the shelter against a wall
or post, on a small pipe, or on a large pipe.
Mounting the Shelter on a Wall or Post
Attach the shelter to the mounting surface in the desired location using the lag
screws and 1/4ʺ flat washers as shown below
Weather ENVOY
.
M OUNTING ON A W ALL OR P OST
Mounting On a Pipe
Hold the rear of the shelter and the U‐bolt saddles against the pipe and slide
the ends of the U‐bolts through the holes in the saddles and shelter so that the
U‐bolts wrap around the pipe as shown below. Secure the shelter using a flat
washer and hex nut on each end of the U‐bolts. Tighten the hex nuts until the
shelter is firmly attached to the pipe.
If mounting on a pipe with outside diameter between 3/4" and 1-1/4"
(19 mm and 31 mm) use the 1-1/2" U-Bolts and saddles, and the 1/4"
washers and hex nuts.
Weather ENVOY
M
OUNTING ON A
S
MALL
P
IPE