DAVIS Multi-purpose Shelter - Manual (Page 10)

Multi-Purpose Shelter
8
Run any ground jumpers from your system components to the ground lug and
attach using the other #10 washer, lock washer, and hex nut as shown below.
A TTACHING G ROUND J UMPERS TO G ROUND L UG
Ground the MPS using the provided ground wire. If you anticipate heavy
surges, you may wish to use a heavier wire or multiple wires. Cut the ground
wire to the length required to reach from the MPS to a suitable ground.. The
ground wire should be as short as possible. Strip both ends of the ground wire
(remove the spade lug if necessary) and insert one end into the ground lug.
Secure in place by tightening the ground lug screw. Attach the other end to a
suitable ground.
G
ROUNDING THE
MPS