DAVIS Mounting Pole Kit Installation User Manual
Mounting pole kit installation manual, Components, Secure the iss to the support tube
Table of contents
Document Outline
- Mounting Pole Kit
- Installation Manual
- Components
- Secure the ISS to the Support Tube
- Mount the Extension Tube
- 1. In a fence-post or other flat vertical surface, drill two holes, using one of the 1-1/8" saddles as a guide.
- 2. Drill another set of holes at least 12" (0.3 m) away from the first holes.
- 3. Using the 5/16" flat washers and lag screws, secure the saddles against the extension tube and into the post.
- 4. Tighten the lag screws until the tube will not slide up or down no matter how hard you try to move it.
- Install the Support Tube on the Extension Tube
- 1. Insert the swaged end of the support tube in the open top of the extension tube.
- 2. Place the U-bolt provided in the mounting pole kit around the tubes where they overlap. Secure with flat washers, lock washers, and hex nuts as shown in the illustration.
- 3. Tighten the hex nuts quite firmly, until the U-bolt begins to dent the tubing slightly. We recommend the use of a torque wrench with 25 lb-ft of pressure to fasten the hex nuts.
- Note: Do not use over 25 lb-ft torque wrench, it may damage the U-bolts.