Telenav for Sprint Supported Devices: v5.2 for Samsung M500, M610; Sanyo M1, SCP-8400, Katana 6600 - Manual (Page 24)

© TELENAV, INC. 2003-2007 PAGE 24 OF 73
3. Because the phone can only do one function at a time, it cannot make
a call and run TeleNav GPS Navigator at the same time, so the phone
will automatically exit from the TeleNav GPS Navigator application
when you make a call.
4. Follow the voice prompts to dictate an address.
5. Re-launch TeleNav GPS Navigator after speaking your directions.
6. Go to the Recent Places list and click Refresh Recent Places (select
Drive To or View Maps, and then select Recent Places). The location
you entered by speaking will appear at the top of your Recent Places
list after your re-launch TeleNav GPS Navigator and click “Refresh.”
NOTE: You must refresh the recent places in order to see the address that
you called in.
The following section contains an example of what you might hear and say when using the Speak It option for
entering an address.
TeleNav prompt> Welcome to TeleNav! Let’s get your destination. Is it a street address, an intersection,
or an airport?
Your response> Street Address
TeleNav prompt> OK, Tell me the 5 digit ZIP code, or the city and state, like Los Angeles, California.
Your response> Arlington, Texas
TeleNav prompt> I heard Arlington, Texas. Say GO BACK if this is not correct. Say the street
including both the number and name, like 422 Main Street. It can also be a highway.
Your response> 1620 Oak Street
TeleNav prompt> I heard 1620 Oak Street. Say GO BACK if this is not correct. Great, your
destination has been entered: 1620 Oak Street, Arlington, Texas 75210. Would you like to enter another?
Your response> Silence (assuming that 1620 was correct)
TeleNav prompt> Thanks for calling TeleNav.
The call is terminated and you are automatically returned to the Sprint Preview menu.