ADT Security Services Unimode 9600 - Manual (Page 94)

3URJUDPPLQJ 0DVWHU 3URJUDPPLQJ /HYHO
8QLPRGH 31 &
3.6.11 Clear Program
Pressing 2 while viewing Programming Screen #4, will select the Clear Program option.
This will cause the LCD to display the following screens:
Pressing 1, for Whole System while viewing the Clear Program Screen #1, will clear all
general system programming options and all programmed addressable devices from the
nonvolatile memory of the FACP. This function is useful when the control panel is first
installed, prior to autoprogramming. Note that it is necessary to autoprogram after using
the Clear Whole System function.
Pressing 2, for All Loops while viewing the Clear Program Screen #1, will clear all
programming related to all SLC loops and connected addressable devices.
Pressing 3, for Loop 1 while viewing the Clear Program Screen #1, will clear only the
programming related to SLC Loop 1 and the connected addressable devices.
Pressing 1, for Loop 2 while viewing the Clear Program Screen #2, will clear only the
programming related to SLC Loop 2 and the connected addressable devices.
Before executing any of the Clear commands listed above, the control panel will provide a
warning to the user by prompting with the following display:
Pressing 1 will cause the control panel to carry out the selected clear option. Pressing 2
will prevent programming from being cleared.
PROGRAMMING
1=PASSWORD CHANGE
2=CLEAR PROGRAM
3=LOAD PROGRAM
Programming Screen #4 @@@CLEAR@PROGRAM
1=WHOLE@SYSTEM
2=ALL@LOOPS
3=LOOP1
@@@CLEAR@PROGRAM
1=LOOP2
Clear Program Screen #1
Clear Program Screen #2
See Page
@@@@@@WARNING!
@@SYSTEM@CHANGE
@@@@@PROCEED?
1=YES@@@@@@@@@@@2=NO