ADT Security Services Unimode 9600 - Manual (Page 42)

3URJUDPPLQJ 0DVWHU 3URJUDPPLQJ /HYHO
8QLPRGH 31 &
3.6 Master Programming Level
When the Master Program Level password is entered, the control panel will enter user
Programming mode. In this mode, the piezo sounder remains off, the trouble relay is
activated and the system Trouble LED flashes until Programming mode is exited. The
following display will appear:
The down arrow which appears in the display indicates that additional programming
choices can be viewed by pressing the down arrow key on the keypad. If a down and up
arrow appear in the display, pressing the ‘down’ arrow key will display the subsequent
Programming Screens as illustrated below while pressing the ‘up’ arrow key will display
the previous screen.
@@@@PROGRAMMING
1=POINT@PROGRAM
2=ZONE@SETUP
3=LOOP@SETUP
Programming Screen #1
@@@@PROGRAMMING
1=SYSTEM@SETUP
2=AUTOPROGRAM
3=VERIFY@LOOPS
@@@@PROGRAMMING
1=HISTORY
2=WALKTEST
3=OPTION@MODULES
@@@@PROGRAMMING
1=PASSWORD@CHANGE
2=CLEAR@PROGRAM
3=PROGRAM@CHECK
Programming Screen #2
Programming Screen #3
Programming Screen #4