Lokar Automatic Trans Mount Shifter TH350 User Manual

Page 5

INS0079 Rev. 07/31/14

Page 5

Step 15: Check the adjustment of the shifter by placing the shifter all the way

forward into the Park position. Make sure that the release button still
moves up and down freely. The release button should be flush with
the knob in Park and Neutral. In the Reverse position, you cannot
pull the lever back into Neutral without depressing the release
button.

While the shifter is in the Park position, make sure the transmission
is firmly in the "Park" detent, with no tension on the threaded rod.
You can verify this by removing the 1/4"-28 x 1" button head bolt
with nylock nut that attaches the rod end to the quad lever or trans
gear lever at either end of the threaded rod. Make sure the hole in
the rod end exactly aligns with the hole in the quad lever or trans
gear lever. The bolt should pass freely through both holes at the same
time without binding. Do not force the holes to line up.

If the holes are not aligned, screw the rod end in or out just enough
to be able to slide the bolt in and out without putting tension on
the threaded rod. Make sure that the quad lever and trans gear lever
do not move during the adjustment procedure. Use this adjustment
routine until the bolt will pass freely in and out of both the rod end
and the quad lever or trans gear lever. Reinstall the 1/4"-28 nylock
nut and the flat washer onto the bolt and tighten.

Once you have the shifter adjusted correctly, tighten the jam nuts on
the threaded rod.

Fig. 10

Fig. 11

Fig. 12

Trans
Gear
Lever

1/4"-28 x 1"
Button Head Bolt

Switch Plate

Neutral Safety
Switch and Washer

Center Groove
in Shifter Body

Rod
End

NOTE: The bolt can be installed from
either side, but make sure the rod
end is sandwiched between the flat
washer and the trans gear lever.

Threaded

Rod

1/4"-28

Jam Nut

1/4"-28

Nylock Nut

Flat

Washer

Right Side

Banana

Bracket

5/16"-24 x 3/8”

Button Head Bolts