Lokar EC-8002HT (38-48 Dodge) Connector Cable - Manual

Building American Quality… With A Lifetime Warranty!
Connector Cable Installation Instructions
Part# EC-8002U & EC-8002HT (38-48 Dodge)
For Under-the-Dash Hand Operated Emergency Brake
Connector Cable Installation
Step 1: Install outer housing to hand brake with bracket as
shown in Fig. 1.
Step 2: Run housing back to rear cables. If you are using a
Lokar Universal Rear Emergency Brake Cable Kit,
mount connector cable bracket 9 1/2” from rear
cable adjuster as shown in
Fig. 2.
Step 3: Run inner cable from hand brake, using clevis at
hand brake. Make sure hand brake is in the full off
position.
Step 4: Be sure to adjust the adjusters all the way in when
connecting cables as shown in Fig. 2.
Step 5: Adjust all cables as needed to remove any slack.
Fig. 1
Fig. 2
9 1/2”
Connector Cable Installation
EC-8002U & EC-8002HT (38-48 Dodge)
General Installation Notes:
Please read instructions completely before beginning
installation. If you have any questions please call.
NOTE: Before starting installation, set parking brake
and scotch vehicle to avoid accidental movement of
the vehicle. Disconnect battery cable before starting
installation.
© 2005 Lokar, Inc. Rev. 5/3/05
10924 Murdock Dr. • Knoxville, TN 37932
TOLL FREE 1-877-469-7440 • (865) 966-2269 • FAX (865) 671-1999 • [email protected] • www.lokar.com