Lokar TCB-40LS14 LS1 Throttle Cable and Cruise Control Bracket - Manual

Building American Quality… With A Lifetime Warranty!
General Installation Notes:
Please read instructions completely before beginning
installation. If you have any questions please call.
NOte: These Brackets are designed to be used with
Lokar Throttle and Cruise Control Cables.
ImpOrtaNt: The large throttle body cams
have a slightly different angle compared to the
small throttle body cams. For smooth opera-
tion, be sure that you have purchased the LS1
Bracket that is correct for your application.
LS1 Throttle Cable Bracket Installation
Step 1: Install the Lokar Billet Aluminum Throttle Cable
Bracket to the mounting boss on the side of the intake
manifold. Be sure the cable mounting stud is below the
two mounting bolts.
photo 1
Step 2: Remove the two aluminum adjuster nuts from the
Lokar adjuster fitting on the Lokar Throttle Cable. Replace
the two 9/16" nuts with the one 1/2" nut that is supplied
with the LS1 Throttle Cable Bracket. This adjuster nut
is smaller and will be easier to tighten against the stud.
Install the throttle cable fitting into the stud with the nut
against the flat. Thread the adjuster fitting into the stud
until there is approximately 1/4" of thread protruding
through the stud. Jam the adjuster nut against the stud.
Repeat this process for the cruise control cable.
photo 2
Install the Lokar Throttle Cable and Cruise Control Cables
pursuant to the instructions included with Lokar’s cables.
10924 Murdock Dr. • Knoxville, TN 37932
TOLL FREE 1-877-469-7440 • (865) 966-2269 • FAX (865) 671-1999 • [email protected] • www.lokar.com
LS1 Throttle Cable Bracket
LS1 Throttle Cable and Cruise Control Bracket
®
Part # TCB-40LS1, TCB-40LS13
Part # TCB-40LS12, TCB-40LS14
© 2008 Lokar, Inc. Rev. 11/18/08 - RPD 06/28/10
LS1 Throttle Cable Bracket
LS1 Throttle Cable and Cruise Control Bracket
Part # TCB-40LS1, TCB-40LS13
Part # TCB-40LS12, TCB-40LS14
Installation Instructions
Photo 1
Photo 2
1998 / 1999 Gm throttle Body - Small throttle
cam assembly is approximately 3" from top to
bottom. Use TCB-40LS1 or TCB-40LS12
2000 / 2002 Gm throttle Body or 2004 GtO
throttle Body - Large throttle cam assembly is
approximately 3 1/2" from top to bottom. Use
TCB-40LS13, or TCB-40LS14