Lokar Stainless Steel Carburetor Bracket & Stainless Springs - Manual

Building American Quality… With A Lifetime Warranty!
General Installation Notes:
Please read instructions completely before beginning installation.
If you have any questions please call.
Before starting installation, use wheel chocks to block the
vehicle's wheels. Do not attempt to install this product while the
engine is running. Disconnect the negative battery cable before
beginning installation.
The Lokar Stainless Steel Carburetor Bracket and Stainless Springs kit
is designed to be used with a Lokar Throttle Cable.
Step 1: Remove the carburetor base mounting bolt from the left
rear corner of the carburetor, and position the Lokar
carburetor bracket as shown in
Fig. 1. Install the carburetor
base mounting bolt only finger-tight.
Step 2: Position the carburetor bracket so that the bend that is
labeled in Fig. 1 is parallel to the carburetor base front to
back.
Step 3: Tighten the set screw until it touches the carburetor base,
and then lock it in place with the jam nut.
Step 4: Tighten the carburetor base mounting bolt.
Step 5: If you are using a kickdown cable, install the tear drop
between the kickdown connector and the carburetor
throttle arm. Connect the springs to the carburetor bracket
and the tear drop.
If you are not using a kickdown cable, the tear drop is not
required. The front of the springs can be hooked directly
into the carburetor throttle arm through the hole for the
kickdown connector. If you prefer to use the tear drop
anyway, you can attach it to the carburetor throttle arm
using a 1/4" diameter bolt and nut (not supplied) through
the kickdown connector hole, and then hook the front of
the springs into the tear drop.
TOLL FREE 1-877-469-7440 • [email protected] • www.lokar.com
®
Stainless Steel Carburetor Bracket & Stainless Springs
Installation Instructions
Stainless Steel Carburetor Bracket & Stainless Springs
Installation Instructions
INS0001 Rev. 03/05/13 RPD 06/03/14 Page 1 © 2005 Lokar, Inc.
Carburetor
Bracket
Carburetor Base
(not included)
Mounting Bolt
(not included)
Bend
Set
Screw
Jam Nut
Carburetor
Throttle Arm
(not included)
Hole for Kickdown Connector
(Stainless Springs may be connected
here if not using a Kickdown Cable)
Tear Drop
Stainless Springs
Front
Fig. 1