Lokar TCB-40DQ Billet Aluminum Throttle Bracket & Springs For Edelbrock And Carter AFB - Manual

Building American Quality… With A Lifetime Warranty!
WARNING: Disconnect battery before beginning
installation. Make sure vehicle is in Park. Before mak-
ing adjustments and taking shifter out of gear, be sure
that the vehicle’s parking brake is set and scotched to
avoid movement of the vehicle.
STOP! Please read all installation instructions before
beginning installation. Call Lokar for any questions or
uncertainties during the installation.
NOTE: This bracket is designed to be used with
Lokar Cables.
Installation Instructions for Billet Aluminum
Throttle Bracket & Springs for Edelbrock
and Carter AFB
Step 1: Install Throttle Cable Bracket to rear carburetor base
with the two supplied mounting bolts. Photo 1
Step 2: Install return spring tear drop to carburetor linkage
arm. This will be held in place by the kickdown con-
nector stud.
Photo 2 If kickdown is not being used,
bolt the return spring tear drop to carburetor linkage
arm using 1/4 x 1/2 bolt and nylock nut. Tighten
until snug, then back off nut enough for tab to
swing freely.
Step 3: Install springs to aluminum bracket and return spring
tear drop tab. Photo 3
Step 4: Install Lokar Cables according to the instructions
included with the cables.
10924 Murdock Dr. • Knoxville, TN 37932
TOLL FREE 1-877-469-7440 • (865) 966-2269 • FAX (865) 671-1999 • [email protected] • www.lokar.com
Billet Aluminum Throttle Bracket & Springs
For Edelbrock And Carter AFB
®
Part # TCB-40DQ
© 2007 Lokar, Inc.
Rev. 11/15/07
RPD 07/27/10
Billet Aluminum Throttle Bracket & Springs
For Edelbrock And Carter AFB
Part # TCB-40DQ
Installation Photos
Photo 1
Photo 2 Photo 3