Lokar Automatic Trans Mount Shifter TH400 User Manual

Page 5

INS0080 Rev. 05/09/14

Page 5

Step 15: Check the adjustment of the shifter by placing the shifter all the

way forward into the Park position. Make sure that the release
button still moves up and down freely. The release button should
be flush with the knob in Park and Neutral. In the Reverse
position, you cannot pull the lever back into Neutral without
depressing the release button.

While the shifter is in the Park position, make sure the transmission
is firmly in the "Park" detent, with no tension on the threaded
rod. You can verify this by removing the 1/4"-28 x 1" button
head bolt with nylock nut that attaches the rod end to the quad
lever or trans gear lever at either end of the threaded rod. Make
sure the hole in the rod end exactly aligns with the hole in
the quad lever or trans gear lever. The bolt should pass freely
through both holes at the same time without binding. Do not
force the holes to line up.

If the holes are not aligned, screw the rod end in or out just
enough to be able to slide the bolt in and out without putting
tension on the threaded rod. Make sure that the quad lever and
trans gear lever do not move during the adjustment procedure.
Use this adjustment routine until the bolt will pass freely in and
out of both the rod end and the quad lever or trans gear lever.
Reinstall the 1/4"-28 nylock nut and the flat washer in its proper
position onto the bolt, and tighten.

Once you have the shifter adjusted correctly, tighten the jam
nuts on the threaded rod.

Fig. 10

Fig. 11

Fig. 12

Quad Lever

1/4"-28 x 1"
Button Head Bolt

Switch Plate

Shifter In Reverse
Position

Neutral Safety

Switch and

Washer

Center Groove
in Shifter Body

Rod End

NOTE: Bolt can be installed from
either side. Make sure Rod End is
sandwiched between Flat Washer
and Quad Gear Lever.

Threaded Rod

1/4"-28 Jam Nut

1/4"-28

Nylock Nut

Flat

Washer

Right Side

Banana

Bracket

5/16"-24 x 3/8”

Button Head Bolts